Solenoid Based Two Directional Double Channel Turnstile Full Height Indoor And Outdoor
Quick Descirption of High Security Gates
Full height turnstile is a kind of access control equipment designed for placeswith high class security requirements. It is easy to combine IC access control, ID access control, code reader, fingerprint, face recognition and other identification devices. It realizes the intelligent and efficient management of passage. The turnstile is the best choice for access control of modern building.
Full height turnstile series are fully applicable to a high traffic flow places like school,factory, park, and other places.
Specification of Full-Height Gate
||SUS 304 stainless steel
||-20℃ ~ 70℃
||Single core 50W,double core 100W
||indoor / outdoor available
||RS485, open/close signal(relay), dry contact
||5 million cycles
Arm rotation angle
|90degree and 120degree
Fire /Emergency Alarm
||Stadium, factory, amusement park, government security, public transportation
Features of bi-directional turnstile
DOOR’s full-height barrier combines maximum security with a rugged and swift design to prevent climb-over attempts and tailgating in unmanned areas.
Available in a variety of styles
DOOR's full height turnstile is available as an indoor or outdoor turnstile, a single or double unit, and with your choice of motorised or mechanical side gates in a number of finishes, including stainless steel and galvanised paint in RAL colours.
Turnstiles System Operation Principle
1) Turn on the power, 2 seconds later; the system enters into work mode; the arm can’t be turned.
2) After swipe legal card or code and fingerprint, Access control device send opening signal to control board.
3) The control board receives open signal, control indicator to green,6 solenoid open , The arm of rotation can be pushed to 90 degree or 120 degree.
4) After the passenger push rod and then rotation turn to 90 or 120 degree, the position sensor send close signal to control board, the solenoid lock immediately.
5) Full turnstiles will lock after 5 seconds if the passenger swipe card but do not pass.
FAQ about turnstile
Q1:When access board send open sigal,arm move reverse and indicator show reverse?
Reasons:open signal reverse connection
Solotion:exchange SW1 GND and SW2 GND terminal of board.
Q2: Indicator is not working?
Reasons:1. wires loose 2.indicator or board damage
Solution:1.Check connect wire of indicator 2.Repalce indicator or board.
Q3: How to achieve free for one way ?
1.Remove one of square solenoid
Q4: Arm can not push when swipe card and indicator show green?
Solution: 1.Check 24V GND output for square solenoid 2.Replace new board or solenoid
Q5: Passing two or three people after swipe card at a time.
Reasons: 1. The Positon sensor didn’t be touched by the right screw cap when the turn plate rotating. (Or didn’t receive the effective signal even touched)
2.The square solenoid does not stretch smoothly.
3.Control baord damageSolution: 1.Move the position senor inward ,Check connect wires to board
2.Adjust square solenoid or replace new one.
3. Changing the square solenoid.
4. Replace a new board
Packing of Single Channel Full Height Turnstile
|G.W. (KG/plywood case)